Installation of Flower Lock
*Best if used with artificial arrangements in green styrofoam.
**Leave the vase in the bronze marker while installing the Flower Lock system.
Step 1: Remove artificial flower arrangement from vase.
Step 2: Place both brackets together and place one rubber ring over one end of brackets past the hole. (See fig. 1)
fig. 1
Step 3: Open opposite end of bracket and place around bottom of vase. Place second rubber ring on opposite side of brackets. (At this time there should be one rubber ring on each side of bracket). (See fig 3). If the vase has bronze stripes on the side align end of bracket with them.
fig. 3
fig. 2
Step 4: Put loop of the locking cord (Fig. 2) over vase and place stainless steel hook in bracket hole. IMPORTANT: (Loop needs to be below the bracket on the opposite side before attaching second locking cord). (See fig 3).
Step 5: Repeat step 4 with second locking cord on opposite side. (Fig. 4)
fig. 4
Step 6: Put flowers in vase bringing the last locking cord attached, up and around the base of the flowers and slide white nylon lock, up and over top of vase to tighten cord. (See fig. 5)
fig. 5
Step 7: Repeat step 6 with remaining locking cord. (See fig 6)
fig. 6